twogambinos
03-20-2007, 6:22 AM
:help: Hi folks as simple as they are. my Fluval 304 will not pump! seals look good, impellar spins,full of water, no pumping. I noticed the bottom plastic piece of the impellar magnet was broke off! superglued that. I figure it has to be sucking air someware but Hell if I can see were. Any idea's?
Thanks
The tubes are full of water?
twogambinos
03-20-2007, 6:37 AM
yes I tried several times refilling and restarting but to no avail.:confused:
As a question did you prime the filter or did you just fill the filter with water? If you just filled the cannister with water the entire intake hose is still full of air and this will cause the filter not to work. It is also possible that your glued together impeller isn't working properly. The only other thing I can think of right off is that maybe the impeller cover isn't holding the ceramic shaft in the proper place.