Runing multiple tanks around the has from 1 CO2 Cylinder
- Thread starter snickle
- Start date
Basically a manifold to split the co2 out of the bottle and then needle valve and bubble counter for each tank.
Something like this which has built in needle valves and bubble counters:
Something like this which has built in needle valves and bubble counters:
www.bestaquariumregulator.com
You will need a manifold, needle valves and check valves.
I would split the flow at the regulator in the basement and then split it again upstairs. That way you only need to run one line and use a lot less tubing.
If you want to talk about this over the phone PM me.
You will need a manifold, needle valves and check valves.
I would split the flow at the regulator in the basement and then split it again upstairs. That way you only need to run one line and use a lot less tubing.
If you want to talk about this over the phone PM me.
What I've learned from REX is it is best to have the tank as centrally located as possible and have a needle valve for each tank at the tank, not in the other room. I have 3 tanks off 1 cylinder, the bubble counters are stuck to the side of the tank and the needle valves are right underneath.