I just filled my 28 gallon tank with water for the first time. I added the sand before I put the water in. I did not wash the sand first (will not make the same mistake again).
The tank became very cloudy. I then ran my protein skimmer and powerheads for a few hours. It did not help at all. I then let things settle for about 24 hours with all the equipment off. I noticed great improvement in water clarity. However, I had foam and bubbles everywhere. I decided to run all the equipment again and it immediately became cloudy again.
Now I have a very cloudy tank with foam all over. What should I do? Should I just turn everything off until the water is clear? If i do, I feel like once I turn everything back on again it will immediatley become cloudy. Any suggestions or answers would be greatly appreciated.
The tank became very cloudy. I then ran my protein skimmer and powerheads for a few hours. It did not help at all. I then let things settle for about 24 hours with all the equipment off. I noticed great improvement in water clarity. However, I had foam and bubbles everywhere. I decided to run all the equipment again and it immediately became cloudy again.
Now I have a very cloudy tank with foam all over. What should I do? Should I just turn everything off until the water is clear? If i do, I feel like once I turn everything back on again it will immediatley become cloudy. Any suggestions or answers would be greatly appreciated.