Fix Low Pressure Gauge Milwaukee regulator.

S

sminker

AC Members
Oct 22, 2007
174
0
0
Does anyone know if its possible to open up the low pressure gauge to repair it?

I was dumb and messed it up when pressurizing the regulator. The needle is all the way on the other side. I can see it move when i adjust the knob, but it just stays in the gap where it says PSI and kg/cm2.

i wonder if i can just open it and reset the needle. need to know if its possible or should i just go and order one?
 
Those gauges tend to work on a spring, said spring has probably broken, you can pick up a replacement pressure gauge for reasonably cheap, or go all out and get liquid filled.
 
your gauge is junk, there is no way to repair the gauge, just replace it.
...just the gauge, not the regulator, you could probably pick one up at a welding supply store.

Dont waste your money on the liquid filled gauge, they are primarily for high vibration locations, when the needle shakes violently and you cant read it...the liquid judt dampens the movement of the needle.
 
Geez no need to be snarky
 
You must log in or register to reply here.
AquariaCentral.com
Top Bottom