Upgrading Needle Valve
- Thread starter slapnutz
- Start date
run the stock needle valve at about 20 PSI.
If anything replace the Low side gauge that comes on the regulator.
I've been using one for about 2 years this way with no issues.
I replaced my gauge with a 0-30 psi model.
this is the one I used
http://www.gaugestore.com/prodinfo.asp?number=31332
The lower psi seems to cause bad fluctuations with the stock needle valve. cranking the pressure up to about 20 PSI makes it much more stable.
If anything replace the Low side gauge that comes on the regulator.
I've been using one for about 2 years this way with no issues.
I replaced my gauge with a 0-30 psi model.
this is the one I used
http://www.gaugestore.com/prodinfo.asp?number=31332
The lower psi seems to cause bad fluctuations with the stock needle valve. cranking the pressure up to about 20 PSI makes it much more stable.
Last edited: