How do you clean a lot of sand?

[NJ Devils Fan]

(see topic)

[BLONDIE]

Do you have a manual gravel cleaner?

[slipknottin]

what are you trying to clean? :confused:

[NJ Devils Fan]

Thats not what I mean, sorry. I mean how do you rinse it before putting it in the tank?

[BLONDIE]

I ran mine through cold water until the water ran clear. It takes a long time but did the trick

[NJ Devils Fan]

But what should I put it in to rinse it? I think I heard someone say an old pillow case, would that work?

[BLONDIE]

I actually used a strainer for draining pasta! I suppose it depends on how much sand you've got to clean. I don't think a pillow case would work though cos it wouldn't let much through (unless your pillow case is full of holes!):D

[carpguy]

I've seen a people recommend putting it in a pillow case and rinsing through that. Since I wasn't really able to visualize what they were talking about I took a big piece of cotton (sheet or a pillow case would certainly work) and laid it on top of a spaghetti collander. Rinsed for a little while and scooped the sand out into a water bucket, leaving the finest little particles behind. Dump the grit and repeat until out of sand.

[firetank]

hey,

i used an old pillow case and it works a treat, just sit it under a tap till the water runs clean.....

you might have to do it in 3\4\5 batches to keep it light work.....

:)

[roper930]

Yep, just pour a bit into the pillow case and run the water thru/over it....Just keep rinsing till the water no longer looks like chocolate milk!! :D It works great!

Beth

[slipknottin]

dont even bother. If its a new tank just throw in the sand and start your fishless cycle.

The sand will get loaded with bacteria and the tank will clear on its own.

[carpguy]

The argument against not bothering:

I did a near total water change at the end of the fishless cycle (in conjunction with a major remodel) and wound up kicking up a tremendous amount of fine sediment (I think it was mostly from the laterite in my laterite/sand substrate). Some of the sediment wound up settling unseen (because you couldn't see anything) on top of the heater creating a hot spot and causing it to shatter. I'd keep as much crap out of the water column as possible.

[appaloosatb]

When I rinsed my sand I put it all in a 5gal bucket and tipped it slightly, then ran water from the hose into the bucket until all the water ran clear. It took about 10 minutes altogether.

[125gJoe]

Originally posted by appaloosatb
When I rinsed my sand I put it all in a 5gal bucket and tipped it slightly, then ran water from the hose into the bucket until all the water ran clear. It took about 10 minutes altogether. This is the easiest way...... Make sure you have a new bucket - at least know the bucket is extremely clean before you put the sand in there...

[pinballqueen]

I have another argument against just pouring it straight in (from my first sand experience, several years ago...). I did just that, since I was unaware that it needed to be rinsed. First, I had cloudy water for a week. Second, tiny little particles got pulled up the intake on my HOB filter and burned out the impellor assembly (due to friction).

Pillowcases and buckets work equally well, IMO. The pillowcase is better for smaller amounts (29 gal. or less tank).