Protein Skimmer Question

First off, I'm a bit of a newbie, so pls don't flame me if this isn't entirely correct, but..

wet&wild said:

However, today I read that "skimming" instead literally means skimming the biofilm and bad crap floating on the surface of the water.

Click to expand...

Nah, a skimmer removes organics from the water. Its more complicated than this, but it basically works because the organics are attracted to the boundary between air and water -so you make lots of bubbles in the water which traps the organic waste and it all floats up to your collector cup. This is what people refer to as 'skimming'. It is preferable to supply the skimmer with water from the surface of the tank, as thats where most of the organics collect (for the same reason). Even if you don't collect it from the surface, you are still skimming the same sort of stuff out of the water, which should ultimately reduce the amount of 'film' on the surface -maybe this is what its referring to?

wet&wild said:

Why doesn't it have a biofiltration?

Click to expand...

Biofiltration is generally done separately, probably because there are so many methods out there. People on these forums generally favour (no apologies for my British spelling ) using live sand and live rock as a natural biofilter, especially in a reef system. Bioballs, for example, tend to be 'too' efficient and create large amounts of nitrates, which is pretty much fine for fish only systems but will harm the inverts in a reef setup.

wet&wild said:

Was I supposed to have clipped the pipe so that it would sit at the surface or sumthin?

Click to expand...

I'm not sure how you would skim off surface water with your setup, I plan to put my skimmer in a sump so (apologies if you already know this) the water flows from the surface, down into the sump, through the skimmer, and is then pumped back up into the tank.

wet&wild said:

Incidentally, is there anything, i.e. purigen, or other non-bio-media that I can put in the compartment ..

Click to expand...

I'm not too sure on this one, setups I've seen in the past put a sponge filter before the skimmer for mechanical filtration, and a carbon filter afterwards to help neutralise any chemicals released by corals etc.
I believe the only way to remove ammonia is bio-media of some kind.

Hope this helps!

It's confusing that skimming has two meanings.

A protein skimmer may be more correctly known as a "foam fractionator." Your first idea, and Paul's description are right.

The other meaning of "skimming" is to remove the gunk from the surface. CPR actually makes an attachment for this, that goes over the powerhead to pull the water off the surface. Some say it improves skimming, er, I mean, fractionation, efficiency by concentrating the gunk.

CPR makes two models of bakpak. You have the 2R, which is designed for reefs, and has no biofiltration. The bakpak 2 has a biobale in the output. If you are using live rock and live sand, you won't need the extra biofiltration, and it will only serve to trap debris and ncrease nitrate levels.