I have a very high volume air compressor which has a 1/2 in. barbed air output. I want to run 2 or 3
4 in. air stones from it. but they have the standard thin tubing connections....1/8 in. probably? Anyway,
the usual thin vinyl tubing fits on them. I have spent a lot of time on Amazon and eBay looking for an air valve manifold
which accepts 1/2 in. ID tubing for the inlet air, but have not been able to locate anything like this. I am not sure now whether
even such a thing is made. I could glue some piece of vinyl tubing in that is 1/2 OD into a short piece
of the `1/2 ID tubing to adapt it down to the correct size, but this would reduce the volume of air that can be delivered
a lot, I think. Any ideas?
4 in. air stones from it. but they have the standard thin tubing connections....1/8 in. probably? Anyway,
the usual thin vinyl tubing fits on them. I have spent a lot of time on Amazon and eBay looking for an air valve manifold
which accepts 1/2 in. ID tubing for the inlet air, but have not been able to locate anything like this. I am not sure now whether
even such a thing is made. I could glue some piece of vinyl tubing in that is 1/2 OD into a short piece
of the `1/2 ID tubing to adapt it down to the correct size, but this would reduce the volume of air that can be delivered
a lot, I think. Any ideas?
