Building my first tank (125 gal) and I'm about to install two Eheim canister filters w/ corresponding inlets and outlets. Filters themselves will be located below in the stand.
What I'm wondering is what are the best positions for the inlets and outlets for optimal water circulation.
My plan is to position a spray bar (outlet) at the far left side of the tank at the surface pointing to the right, and the corresponding inlet in the middle of the tank extending straight down to just above the substrate layer. Then right next to that inlet will be the second canister's spray bar positioned in the middle of the tank near the surface pointing right, and then that filter's inlet will be on the far right side of the tank in the corner again extended down to just above the substrate.
Does this sound ok for an inlet/outlet setup or is there a better arrangement I should consider?
Thanks
What I'm wondering is what are the best positions for the inlets and outlets for optimal water circulation.
My plan is to position a spray bar (outlet) at the far left side of the tank at the surface pointing to the right, and the corresponding inlet in the middle of the tank extending straight down to just above the substrate layer. Then right next to that inlet will be the second canister's spray bar positioned in the middle of the tank near the surface pointing right, and then that filter's inlet will be on the far right side of the tank in the corner again extended down to just above the substrate.
Does this sound ok for an inlet/outlet setup or is there a better arrangement I should consider?
Thanks