Results 1 to 7 of 7
  1. #1
    SatCan
    Usergroup
    AC Members
    Join Date
    Sep 2004
    Location
    Toronto, Canada
    Last Activity
    12-18-2006 4:30 PM
    Posts
    4,535

    Choosing/Cleaning A Filter

    Hereís a short article about cleaning/replacing your filter media:

    There are 5 main types of filters. I am only going to include filters that clean out stuff from your aquarium, not chemical, light(UV), specialty, in tank (who uses them anymore).. The filters job is to remove solid waste from your water. This can include food, fish poo, plant matter, and anything else that may happen to be in your tank.

    HOB (Hang On Back):
    This is one of the most common filters out there. Itís a box that sits on the back of your tank and holds your filter media. The filter media traps the garbage in your tank and keeps it there until you clean it out. These filters are great for beginners but for planted tanks they arenít the best because they gas off Co2. Common brand names include: AquaClear and Marine Landís Bio Wheel.

    Canisters:
    This is my favourte type of filter. It's basicaly the same as a HOB, but its not hanging onto the tank. Instead itís underneath or to the side of the tank. A pipe sucks water in, it flows through some media (same idea as a HOB) and returns to the tank via a spray bar. A spray bar is a pipe with many holes drilled into it for the water to exit from. These are the best for planted tanks because most of the Co2 will stay dissolved in the water.

    Sumps:
    These are more common in salt water tanks. In the tank thereís a hole drilled, or a tank overflow that takes water out of the tank to a certian level and drains it to a glass or plastic box under the tank. There it flows through many chambers where media, bio media, chemicals, sand, etc are kept. In the last chamber is a pump that returns the water back into the tank.

    UGF (Under Gravel Filters):
    These filters go under the gravel (hence the name) and have two exit tubes on the ends. Water flows through the gravel and into the collection plate. It then goes into the uplift tubes where it is returned into the tank. The filter is powered either by an air pump or a power head. IMO these are the worst and are too ďold schoolĒ when compared to the others listed above. If something breaks you have no choice but to destroy the whole tank because itís under the gravel. If not cleaned properly they can become nitrate factories. A better choice would be RUGJ or Reverse Under Gravel Jets.

    Sponge Filters:
    These filters are really basic. Itís a sponge, a stand, and an uplift tube. Normally powered by an air pump or a power head. Water comes in through the sponge and out the uplift tube. These are great for fry tanks as there are no moving parts, and they can not get sucked into them.

    Cleaning a filter:
    With any filter cleaning is basically the same because they all use the same media. Cleaning a filter is very important for its proper function.

    Sponges:
    These are super easy to clean. Once every 2 weeks you can take them out and swish them around in some old tank water or some water that has no chlorine in it. Reason being chlorine will kill the bacteria in it. They only need to be replaced when they are falling part. I have had mine for over a year.

    Carbon:
    Carbon is not needed in a normal tank. Carbon takes out meds, color, and odor. None of which should be present in your tank always (except if you have driftwood). It will become un active in about 2 weeks. After that it is useless and will not be doing anything.

    Bio Media:

    Bio media is any media that is designed to house bacteria. They can be ceramic noodles, Bio Max, plastic Bio Balls. They only need to be cleaned in old tank water every few months. As long as they are not clogged it should be fine.

    Choosing and maintaining your filter will make fish keeping much easier. Filters are a must. Itís the life support for your fish. Without it, everything may die because nothing is cleaning out the gunk thatís in your tank. There are some filters less tanks that use plants as a natural filter. This gives a nice effect but is not the easiest thing to do. Good luck with your fish keeping!





  2. #2
    Purple is the color of Royalty daveedka's Avatar
    Usergroup
    AC Members
    Join Date
    Jan 2004
    Location
    Columbus, ohio
    Last Activity
    04-11-2011 6:03 PM
    Posts
    3,822
    Additional thoughts comments and info:

    HOB's as a general rule oxygenate water as well or better than anything out there (downside when injecting Co2), they are extremely cost effective, and very easy to clean/ maintain


    Canisters should not be campared closely to HOB's in my opinion. Cannisters have a distinct advantage of not bypassing water, therefore they do an exceptional job of polishing water, with lower total flow values than an HOB. they will plug completely without bypassing as a rule, where-as an HOb will allow water to wash around plugged media. This can be a good or bad feature depending on your personal preferences and maintenance.

    Additionally a good canister is dead silent, and is far more versatile in media options than an out of the box HOB. both can be custamosed, but a cannister is usually built for versatility while an HOB is built for pre-made cartidges and sponges.

    The downside to cannister is generally up-front cost.

    Sumps as raule allow a lot of flexibility, both for media and accessories. Heater/chillers are easily palced in sumps, leving less to hide in the tank. sumps also have the capability of wet dry biological filtration. The downside is space and to some degree cost, the upside is versatility.


    UGF/ RFUG Come on Kas, I know you can do better on this one. Greatly mis-understood does not make it bad. this filter will run longer on poor maintenance than any other format in existance, It costs less than just about anything else, and requires less additional work to maintain than anything else. All tanks need routine vaccuming, so since you should already be doing this, it isn't extra work to do it for your UGF. In the case of RFUG the filter virtually eliminates the need to vaccum. UGF's are no more old school than cannisters, sponge filters, or sumps. UGF's are no more of a nitrate factory than any other filter available. And in addition nothing but a diatom filter will polish water as well as a ugf, and a diatom will require much more maintenance and cost. UGF's are quieter than HOB's, provide better bio-filtration than Cannisters, clean better than diatoms and cost less than any of them. Everyone has their favorite way to filter, but please don't knock a good filter based on rumors or hearsay.

    And BTW, you can clean a ugf without tearing it down, and I really have never ever seen one break under the gravel, so I have no idea why one would need to tear down the system to fix it.
    Dave



  3. #3
    SatCan
    Usergroup
    AC Members
    Join Date
    Sep 2004
    Location
    Toronto, Canada
    Last Activity
    12-18-2006 4:30 PM
    Posts
    4,535
    I fixed it? I updated it in MS Word. Maybe I copyed and pasted the wrong one



  4. #4
    SatCan
    Usergroup
    AC Members
    Join Date
    Sep 2004
    Location
    Toronto, Canada
    Last Activity
    12-18-2006 4:30 PM
    Posts
    4,535
    I have an updated UGF and one more topic for cleaning. Weird. Ill post it later when Im on my other PC that has it.



  5. #5
    Member
    Usergroup
    AC Members
    Join Date
    Mar 2005
    Last Activity
    06-25-2007 2:43 PM
    Posts
    95
    2 things,
    1. are there any canister models with bio-wheels, because the bio-wheel, inmy opinion, is what makes the hob.

    2. give me some tips on how to make subsitutes for those pain in the arse cartridges without sacrificing effectiveness for moola.


    would that be an african or european swallow?



  6. #6
    Senior Member Pretender's Avatar
    Usergroup
    AC Members
    Join Date
    Sep 2005
    Location
    Space Coast of Florida
    Last Activity
    05-31-2006 8:57 AM
    Posts
    197
    In the interest of accuracy, Marineland's Bio-wheel is a component of several of their products, and by itself is not a HOB filter (which seems to be more popularly known as a power filter, as there are hand-on-back versions of other filters such as hang-on-back cannisters.) Marineland's power filters, or HOB, in this context, are the Penguins and Emperors.

    You can get a Bio-wheel by itself, and it acts as a return for a cannister filter instead of a spray bar or other mechanism. It does hang on the back of the aquarium, but is intended as only part of a complete filtration system.
    "For an Amphiprion ocellaris, you're not very funny."



  7. #7
    Senior Member
    Usergroup
    AC Members
    Real Name
    Rachel O'Leary
    Join Date
    Feb 2007
    Location
    PA
    Posts
    18,306
    Blog Entries
    2



Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Filter Maintenance And Cleaning Tips
    By GoldLenny in forum Equipment and DIY
    Replies: 5
    Last Post: 06-26-2008, 11:33 AM
  2. eclipse filter modification?
    By randalizm in forum Freshwater Equipment, Products, & DIY
    Replies: 5
    Last Post: 06-09-2005, 6:17 PM
  3. filter maintenance
    By MJMiller in forum Freshwater Equipment, Products, & DIY
    Replies: 3
    Last Post: 12-15-2003, 2:44 PM
  4. Bacterial Colony Follows Filter?
    By phpKerouac in forum Freshwater Newbie Forum
    Replies: 1
    Last Post: 11-23-2003, 10:59 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •