I was wondering if anybody tried to connect a diy rex reactor in a fx5, with 1" tubing?? Is it possible to find all the fittings?
Anybody have a rexgrigg co2 reactor inline with a fx5 fluval?
- Thread starter aquaholic
- Start date
Go to home depot or lowes. The plumbing and pvc section has all kinda clamps, tubing, fitting, caps, etc.
well how much of the current tubing do you have?
You should have enough already to go from your filter to the reactor and then buy some to go from the reactor to the spray bar. I suggest you get the black tubing, it's stylish and you don't have to worry about algae.
Im not familiar with your filter and looking at how much extra the ribbed tubing is youd be better off with the above.
also to add. Take your current tubing to the store with you and just match it up with the closest size, it will say on the box or a tag that it's aquarium safe.
You should have enough already to go from your filter to the reactor and then buy some to go from the reactor to the spray bar. I suggest you get the black tubing, it's stylish and you don't have to worry about algae.
Im not familiar with your filter and looking at how much extra the ribbed tubing is youd be better off with the above.
also to add. Take your current tubing to the store with you and just match it up with the closest size, it will say on the box or a tag that it's aquarium safe.
Last edited:
Found everything
$20 and the reactor pieces are all ready to go had to change some fitting a bit but its ok.
$20 and the reactor pieces are all ready to go had to change some fitting a bit but its ok.