10 gallon filter advice needed.

Finster

Finster

AC Members
May 20, 2004
164
9
18
69
Missouri
Real Name
Joe
Hi all. I have a Sun Sun canister filter rated at 265 GPH. Right now, it's keeping the water parameters perfect and crystal clear in a 29 gallon tank that's temporarily over loaded with turtles. The tank is bare bottom, but the flow certainly doesn't seem overwhelming in the 29. Can anyone advise on the possible use of this filter in a 10 gallon lightly planted Bolivian Ram specimen tank with a sand substrate? Any similar set up experience?

Thank you much!
 
It would probably work, but to be safe I'd find a spare intake cap and see if you can put it on the output. If you can't then the flow is more than it looks and you should avoid putting it onto the 10gal. If you can, keep it on the output to help prevent it from blowing sand around and baring roots over time, or use a rock to do so.
 
IMO it maybe too much for a 10gal. Your flow maybe low because of the length of the hoses. If you cut/shorten the hoses I am sure the flow rate would increase.
 
My Sunsun 302 has a very underwhelming flow rate to it as well. It wouldn't stir up a 10g by any means. I only ran the spray bar on it for a week or two and have just run the elbow ever since. Obviously you'd have to shorten the intake a bit and maybe put a smaller suction strainer on it to take up less space.
 
Sounds like it might be worth a try then. Anyone know what would be the best way to restrict the flow a little if I need to? I have a pvc ball valve I can rig, but I don't know if it would be better for the filter to do it on the intake or output.
 
I wouldn't restrict the flow with a ball valve. You can put a "tee" on the end of the outflow tube, provided you can find one to fit. Put the middle leg of the tee on the outflow and let it divert the stream two directions. That will mitigate the current somewhat.

Mark
 
Other options would be to make a spraybar with lots of holes in different directions, or to have the outflow connect to an UGF and have the water return up through the substrate.
 
I can't comment on this make of filter since I do not know it, but I would be concerned over the filtration/current in a planted 10g and especially with this species Mikrogeophagus altispinosus.

M. altispinosus (Bolivian Ram) occurs in very slow-moving waters, namely the quiet streams in the Rio Guapore and Rio Mamore basins, and obviously in flooded forest during the 6-month wet season. It does not appreciate water currents, and in a 10g it may have no respite from those produced by this filter. I would not go above a sponge filter.

I am assuming by "specimen tank" you only intend one ram. I personally would not have this fish in anything under 20g, or at least a 24-inch 15g. Males attain 3.5 inches, females less. I have had this species for many years; my current solitary male is approaching six years (which is pretty good for a fish with an average 4-year lifespan) and he seems happy in the quiet recesses of my 5-foot tank. While it may work fine, I cannot envisage my male in my 10g.

Byron.
 
Thanks. Lots of great ideas. I will go slow, and "try before I fly". If I can't get it to work, Sun Sun does make an interesting little modular canister that is rated for a 10 gallons.:cool:
 
as Byron pointed out a 10 g is to small for a bolivian ram.

I keep several and they do like larger footprints a 15 is min but a 20 long if better(same footprint as a 29 btw)
 
You must log in or register to reply here.
AquariaCentral.com
Top Bottom