4300 Gallon Plywood Build (3600+ Take 2)

http://www.aquariacentral.com/forums/attachment.php?attachmentid=132111&d=1279267164

Hello Pete, something like this?

Good to hear you're still on it. If you go with the internal filterbox I assume you're still using an external pump? How would your waterflow be? from your existing outlets (from tank to filter) using pressure from the main tank up into the filter with tubes/pipes? Then the external pump pushing it back into the tank?
Or would you have a cut out at the top of the filter where water flows over and into the filter, then pumping it back into the tank using the outlets that you originally meant for getting water into the filter drums?

Your thread is so long by now, hard to look for the exact pages with info on it.
Good luck, hope you get it running asap.
 
One of the concerns I had with selecting a liner was that if I went with the smaller it would be too small and the larger would have too much excess that would be wasted. My super smart wife suggested that I use visquene to test the sizes to see which is appropriate. I'll be getting the visquene I need this weekend and doing a test with the smaller size (the one I think will work perfectly) to see if I'm correct.
 
Spectacular project! My apologies if this has been covered already (I would love to read through each post, but can't seem to find the time)....my question: how will the tank be heated?
 
Still waiting on this build big guy !
 
You must log in or register to reply here.
AquariaCentral.com
Top Bottom