BoCoMo's 40G Reef
- Thread starter BoCoMo
- Start date
Thanks Benson!
Cheech, I got a full zeo start up system available for you if you want! (reactor, lites, bak, start, and food)
The cost isn't too horrible to me it is more the consistant attention that is required. I am probably going to have to get the ATO, RKL, Dosers and all the rest of the automation setup sooner than later if I am going to stick with it. I have also considered putting a vodka reactor in its place.
Cheech, I got a full zeo start up system available for you if you want! (reactor, lites, bak, start, and food)
The cost isn't too horrible to me it is more the consistant attention that is required. I am probably going to have to get the ATO, RKL, Dosers and all the rest of the automation setup sooner than later if I am going to stick with it. I have also considered putting a vodka reactor in its place.
^^ Ha! lol.. Maybe one day I'll take the zeo route... I'll see how my current setup goes for now.
Ptrick125
Learning a lot everyday
Building the sump now then...
Let the plumbing begin
Looks like a weekend's worth of work
Cool tank! I can't wait to see it filled with coral
Sent from my iPad using MonsterAquariaNetwork app
Sump is built:
Rocks are pre-soaking before acid bath:
Tank is drilled:
Measured and marked:
Build a water dam with plumbers putty:
Start drill at medium speed, come at an angle then after started tilt to full bit engagement:
Protips: Drill from the side you will be putting flange and gasket on (to avoid chips on side you will seal, support the side you are drilling to with something like foam or wood. (I drilled from inside out and sat the aquarium on foam), and drill slowly letting the weight of the drill push, once again patience pays off and I avoided chipping out.
Rocks are pre-soaking before acid bath:
Tank is drilled:
Measured and marked:
Build a water dam with plumbers putty:
Start drill at medium speed, come at an angle then after started tilt to full bit engagement:
Protips: Drill from the side you will be putting flange and gasket on (to avoid chips on side you will seal, support the side you are drilling to with something like foam or wood. (I drilled from inside out and sat the aquarium on foam), and drill slowly letting the weight of the drill push, once again patience pays off and I avoided chipping out.
Nicely done. I trust that you reserached the muratic bath process?
Where did you get the overflow box?
Where did you get the overflow box?
