clay pots
- Thread starter pucknut
- Start date
If you just need a small hole in the clay pot, use a drill with a masonry bit (standard bits don't work very well...I've tried). The bit can be picked up at a local hardware store for a few dollars. Drill the pot at a low speed and only apply enough pressure to start the hole. Once the bit catches, let the bit pull itself through the clay.
If you need a larger hole or want to cut off the bottom of the pot, the aforementioned dremmel or rotary tool is best.
If you need a larger hole or want to cut off the bottom of the pot, the aforementioned dremmel or rotary tool is best.
:thud:
thats actually the best way to get bigger holes in it. soak it overnight and then chip away with a hammer or you can score it and strike on the lines. the dremels take too long and you will use up a bunch of cutting wheels.Maj0rFiSh said:A hammer
blitzen25bm said:
I must not have the "hammer technique" down to well. I went through too many clay pots trying the score and chisel method, decided using up cutting wheels was far more to my advantage. Plus, you get a precise hole/opening.
I don't think I soaked them before hammering... :thud:
OK, I gotta ask... What the heck are you using these for, anyway??? (Newbie here, I'll never know if I don't ask, right?)
Clay pots are typically used to make "caves" for fish to hide in.
I did fail to mention in my prior post to soak the clay pots for a few hours or even overnight before drilling/cutting. This makes the clay softer and helps prevent shattering.
I did fail to mention in my prior post to soak the clay pots for a few hours or even overnight before drilling/cutting. This makes the clay softer and helps prevent shattering.
I will be using clay pots in my new tank when i finally get it, i think ill just have to buy a load of pots and give them a good bash and hope some come out like caves