hhelp!
- Thread starter fishguychris
- Start date
What is wrong. "It won't work" is sort of vague. Could be anything from "did you plug it in" to a faulty flux capacitor.
plugged in it just wont work ive primed it all exetera just wont 'work' the water wont go in and go back out
can you hear the motor spining/humming? is the impellor working? is the system not getting water? try sucking water into the lines, then closing off the valve. when you put the valve block back on the canister, open it, and it should start priming the system, all the way up to the head/impellor housing
Are the hoses full of water? The spray wand has to be out of the water to allow a vent path to fill the cannister. You will not hear the pump run. It is very quiet. Are you sure the wall recepticle has power? Did you try to post this on "Freshwater Equipment / Products / DIY" forum. I know there is always a lot of discussion on the sun sun. Does your model have the UV Light? If so, is the blue light lit?