before a top off MUST be made. Im planning a nano tank with some low light corals.
Currently, i have a 2 bulbs fiture with two 20 watts pc lights (spiral, screw in 50/50 bulbs y coralife) in them. They get hot, but i do not have any evaporation with the lid in a week.
Now to grow low-medium light corals, i plan on adding a T5 unit (14 watts x 2), where one bulb is a 10 000K daylight, and the other is a acnic.
Basically, it will be a combination of 50/50 and acnic.
Now, with that said, will adding a T5 fixture cause any more evaporation then i currently get (which is very low in my FW set-up)?? They produce very little heat so im assuming not.
Questions revised......
1. What level of water must go down in a nano tank (15 gallon in my case) before it must be topped off.
2. Will the addition of a T5 to the current fiture cause much more evaporation.
Thanks again.
Currently, i have a 2 bulbs fiture with two 20 watts pc lights (spiral, screw in 50/50 bulbs y coralife) in them. They get hot, but i do not have any evaporation with the lid in a week.
Now to grow low-medium light corals, i plan on adding a T5 unit (14 watts x 2), where one bulb is a 10 000K daylight, and the other is a acnic.
Basically, it will be a combination of 50/50 and acnic.
Now, with that said, will adding a T5 fixture cause any more evaporation then i currently get (which is very low in my FW set-up)?? They produce very little heat so im assuming not.
Questions revised......
1. What level of water must go down in a nano tank (15 gallon in my case) before it must be topped off.
2. Will the addition of a T5 to the current fiture cause much more evaporation.
Thanks again.