alright till tommarow ***** make sure to check the seals before you set it up they may leak and drain you tank mine did i lost 10 gall on my floor overnite wasnt fun to clean we'll cover that tommarow
Mag 350 "sleve"
- Thread starter Lady G
- Start date
if they dont i got a quick fix that will make it ok till you can get a new one or the next time you change the media
Awww, thanks RB...I just did what Cat told me to do 
erv:
So ummm, Cat ready for that "testing" thing yet
erv:So ummm, Cat ready for that "testing" thing yet
yea here is what i would recommend.
fill the filter approx 3/4 full of water. then take 2 buckets fill 1 with water and insert you intake and outflow lines into it. set your 330 into the other empty bucket. plug in and let the unit run the water. keep an eye on the level of the water in the canister. check outflow to see if its steady and suficent. make sure there are no kinks in the hose lines and no leaks from them. check around the lid seal for air sucking in youll hear it and may see bubbles forming around the inside of the lid. if there are none of these evident then id say your good to go.
fill the filter approx 3/4 full of water. then take 2 buckets fill 1 with water and insert you intake and outflow lines into it. set your 330 into the other empty bucket. plug in and let the unit run the water. keep an eye on the level of the water in the canister. check outflow to see if its steady and suficent. make sure there are no kinks in the hose lines and no leaks from them. check around the lid seal for air sucking in youll hear it and may see bubbles forming around the inside of the lid. if there are none of these evident then id say your good to go.
Well, the suckie side is not sucking the water up? I took the plastic part off the hose and ran water through it incase there was a clog...but the water ran right through that part. So, does it just take a while for it to start sucking up the water...know on my HOBs it take a bit to "prime" them up
yes it takes a few minutes to prime. But did you here any air sucking in at all or did the impeller sound like it was haveing a rough time?
