Im selling the longer one. It has 10-12 bio ball in it. I can fit either 17mm (16/22) (5/8) or 3/8" barb in it, just tell me ahead. No leak, work perfectly.
28 shipped usps priority
28 shipped usps priority
FS Medium-sized DIY inline CO2 reactor - Socal - S
- Thread starter Ahura-sama
- Start date
- Status
Lowered down to 25 SHIPPED
That hueg clear pvc alone is like 11 buck. The knick knacks for each end are another easy 11, and the cement, teflon tape and the bio ball etc. Cost me like 30+ just to make one cause returning the cement after one use is just dumb. 25 shipped is super cheapy
Get it
That hueg clear pvc alone is like 11 buck. The knick knacks for each end are another easy 11, and the cement, teflon tape and the bio ball etc. Cost me like 30+ just to make one cause returning the cement after one use is just dumb. 25 shipped is super cheapy
Get it
Oh snap
Yeah, I can fit either 5/8" aka 16/22 aka 17mm; or 3/8" aka 2213's diameter, 12/22?? 13mm". But yeah, just unscrew them out and fit the appropriate one in. Those two barbs are the most common for filter.
Yeah, I can fit either 5/8" aka 16/22 aka 17mm; or 3/8" aka 2213's diameter, 12/22?? 13mm". But yeah, just unscrew them out and fit the appropriate one in. Those two barbs are the most common for filter.
It will work, but here is a better question. Is the flow output important for you on the Magnum??
This reactor will impede the flow quite a bit. It actually would do a better job of dissolving the CO2 at the cost of the weaker flow. Good thing if Co2 dissolution is important to you, bad if you want flow.
I used this on an Eheim 2028 and I get bubble spewing out from the output like mad cause the pump of the 2028 is too dang strong. I get 100% dissolution when used on 2213. Great, but of course flow is quartered at least.
Other than that as long as the tubing fit then it's good to go.
This reactor will impede the flow quite a bit. It actually would do a better job of dissolving the CO2 at the cost of the weaker flow. Good thing if Co2 dissolution is important to you, bad if you want flow.
I used this on an Eheim 2028 and I get bubble spewing out from the output like mad cause the pump of the 2028 is too dang strong. I get 100% dissolution when used on 2213. Great, but of course flow is quartered at least.
Other than that as long as the tubing fit then it's good to go.
Last edited:
Again, you need plastic tubing. Hose clamps and plastic tubing should be able to extend the length of the thing.
Cut the plastic tube in between, fit in the tubinb, should work.
Cut the plastic tube in between, fit in the tubinb, should work.
Inches
Cm is always smaller, both measure and the numbers shown. Plus, CM is too small of a measurement for reactor.
Cm is always smaller, both measure and the numbers shown. Plus, CM is too small of a measurement for reactor.
- Status