This is going to be used for a 30 3/4"L by 10 3/4"h by 18 1/2"w
about 30 gallons or so (I might use a 20L noot sure yet but the stand will be built for the larger one), that will be on top. This will be used for coral propagation.
then in the middle where all the 1X2's are is going to be a 10 gallon fuge... I want it to be big enough to put a 20L in there instead if necessary. And with these measurments it should be.
The bottom is go to be storage with 2 doors and open with shelves in the middle.
My question is, is this enough support for all this? And do you think it will fit? keep in mind me and a buddy are going to measure everything, so it will not be exaxtly like the drawing
about 30 gallons or so (I might use a 20L noot sure yet but the stand will be built for the larger one), that will be on top. This will be used for coral propagation.
then in the middle where all the 1X2's are is going to be a 10 gallon fuge... I want it to be big enough to put a 20L in there instead if necessary. And with these measurments it should be.
The bottom is go to be storage with 2 doors and open with shelves in the middle.
My question is, is this enough support for all this? And do you think it will fit? keep in mind me and a buddy are going to measure everything, so it will not be exaxtly like the drawing
