Hi All,
For the past few weeks I've been noticing that the water line in my 120gal have not been completely "flat", but I thought it's was just my paranoia at work so I never paid much attention to it.
Until last weekend after a waterchange I noticed the angle again and it was getting to me so I got out a ruler and measured the gap between the top of the tank to the waterline and notice there's a 20mm - 40mm difference from one end to another
It was a bit difficult to get an exact measurement due to the moving water line from the filter and difficulty in keeping the ruler straight.
Is this something that I should be concerned with? I've had this tank for years now probably 3 years or so in the same spot, and I didn't think there's an angle until recently.
I did have a few filter leaks in the past year or so and it did wet the stand and carpet and the "soaked" wooden stand might have caused the stand to sink?
Should actions be taken now or should I monitor the waterline and if it gets worse, replace the stand?
Thanks in advance for any tips / adivce.
For the past few weeks I've been noticing that the water line in my 120gal have not been completely "flat", but I thought it's was just my paranoia at work so I never paid much attention to it.
Until last weekend after a waterchange I noticed the angle again and it was getting to me so I got out a ruler and measured the gap between the top of the tank to the waterline and notice there's a 20mm - 40mm difference from one end to another
Is this something that I should be concerned with? I've had this tank for years now probably 3 years or so in the same spot, and I didn't think there's an angle until recently.
I did have a few filter leaks in the past year or so and it did wet the stand and carpet and the "soaked" wooden stand might have caused the stand to sink?
Should actions be taken now or should I monitor the waterline and if it gets worse, replace the stand?
Thanks in advance for any tips / adivce.