Upgrading Needle Valve

[slapnutz]

My Milwaukee Reg is on the way. I have been reading that upgrading the needle valve is a great idea, especially to stop EOTD from happening. Will this work? Trying to keep the cost minimal here...who am I kidding. Like that ever happens.

 

[The Zigman]

run the stock needle valve at about 20 PSI.
If anything replace the Low side gauge that comes on the regulator.

I've been using one for about 2 years this way with no issues.
I replaced my gauge with a 0-30 psi model.
this is the one I used
http://www.gaugestore.com/prodinfo.asp?number=31332




The lower psi seems to cause bad fluctuations with the stock needle valve. cranking the pressure up to about 20 PSI makes it much more stable.