The poster. Your meme is more fitting than you could know, being new here. Just ignore the kid...My meme dude or the poster?
Ummmm....I know what the meme was from....that's why I posted it.Poster.. the meme is a still from Bill + Ted's Excellent Adventure... Go watch it!
Thanks for the heads up; I've been here since 2013, though...The poster. Your meme is more fitting than you could know, being new here. Just ignore the kid...
WYite
Thanks; I asked specifically about the ACs because it's been said that the lower flow rates can yield better contact time with the media, while also allowing for better water polishing. As I said, though, I don't see much of a difference going from low to high.I am not a user or hang on back filters at all if I can help it. So take it with a grain of salt, but I would always let the flow be as high as possible and diffuse the output with foam or something if there was too much current for your tastes.
For pictures . Post anywhere, it should be easy enough to find just by looking at new posts, there are only a couple of handfuls of posts each day
Mot sure where else I could suggest he be put and not be bannedUmmmm....I know what the meme was from....that's why I posted it.
I wasn't sure if you were saying put our man in the meme in an iron maiden or the poster, that's all.
I understand the fact that lower flow will provide more contact with media, and specifically less potential for bypassing that media... but my instinct is that keeping it clean is likely a better solution.Thanks; I asked specifically about the ACs because it's been said that the lower flow rates can yield better contact time with the media, while also allowing for better water polishing. As I said, though, I don't see much of a difference going from low to high.
I'll work on the pics.
Mot sure where else I could suggest he be put and not be banned
But watch it anyway..
??Mot sure where else I could suggest he be put and not be banned